A Portable Solar Water Heater

Most of us have - at one time or one other - longed for the luxury of a sizzling shower whereas on the street or path. Well, there’s no need to yearn any longer, because I’ve provide you with a portable solar water heater that may price you lower than $10 to build and can be folded and carried in a backpack, suitcase, automobile or boat! Not only that, it’s additionally amazingly simple to construct this heating unit. Here’s what you want to put one together: one auto inner tube, a size of used backyard hose, a 1/2-inch plastic pipe coupler, a small clamp, a male hose connector, a hose valve or nozzle, and a few good-high quality rubber-sealing compound. It’s usually potential to scrounge up a free, secondhand inner tube in good condition, or - at worst - buy a used one for no more than $1.50 from a tire store. When you select yours, understand that a 14-inch tube will hold round 19 quarts of water.



1/4-inch hole about two inches in from the outside edge. Now, wet your finger with water, stick it into the outlet, and clean around the inside. Next, take the 1/2-inch pipe coupler and reduce off its lower half, glob a superb quantity of rubber-sealing compound on the small ridge of the coupler, and push it into the 1/4-inch hole. With the lower a part of the coupler in the hole, heat space heater unit pull the ridge up snug in opposition to the inside of the tube and let the cement dry for the utmost time stated on the product’s label. That achieved, heat space heater unit clean across the "new" stem, and heat space heater unit roughen that area just as you'd the heat space heater unit surrounding a gap in an inner tube that’s to be patched. Now, put some rubber-sealer on your finger and heat space heater unit coat the outside area. I’ve discovered that three thin coats will dry faster and provide a stronger seal than one massive glob.



Again, let the cement set completely. Then, all it's a must to do is take about two feet of outdated garden hose, connect it to your new stem (if in case you have an issue slipping the hose on, let it, too, sit in the sun for a while to soften up), and put a clamp around the hose and stem to carry them collectively. Finally, you’ll need a normal nozzle on the other finish of the hose. When I used to be constructing my heater, I used the tip of an old hose that still had the male connector heat space heater unit on it - to which I may attach the water control valve. However, in the event you don’t discover such a bit, you may buy a backyard hose restore package - which can contain the fitting you want - for lower than $1.